Closing a Restaurant for Extended Periods

Best practices and considerations when your restaurant is closed.


Coronavirus has had an impact on the ability of businesses to perform daily obligations. It is prudent for businesses to review procedures underlying their commercial relationships impacted by this pandemic.


Closing a Restaurant for Extended Periods

Since every restaurant is different in its design and complexity, it is impossible to establish standardized procedure for partial or full closure for all restaurants. We have compiled a list of things to consider when taking necessary steps to close your restaurant temporarily. Taking these steps now will help you get your kitchen back up and running quickly when you’re ready to reopen.

Many large losses are attributable to incidents that occur after working hours or when a property is closed. Most of these losses can be prevented by a careful check of the premises at the time of closing, and periodically during the closure.

Download Best Practices for Closing a Restaurant

Below are some best practices and suggestions to consider when preparing for partial or full closure:
  • Shut off water heaters
  • Shut off gas hookups to equipment
  • Check for gas leaks
  • Maintain HVAC in the 50*F’s but in the event of extreme changes in temperature this may need to be adjusted with periodic checks of the facility.
  • Remove grease from frying units and thoroughly clean
  • Move remaining food to walk-in coolers/freezers
  • Flush beer taps; cover and seal liquor bottles
  • Ensure all trash and towels/rags used for cleaning grease have been removed from the building
  • Establish a “rapid response” team to assist fire or police, in the event that they should be called to the site
  • Establish a communication tree for the shutdown and communicate to all employees. Advise employees that if the information does not come from those identified on the communication tree, they should verify the information with the appropriate contact
Equipment/Mechanical Systems

Shut off all pumps

Shut off all-natural gas or electric equipment

  • Close gas valves – ensure that pilot lights are extinguished
  • Shut off circuit breakers

Shut off all powered venters once the gas has been turned off

Establish “rounds” throughout buildings to assure that interior conditions, building openings, and equipment are maintained and repair if needed


Flush Your Beer Taps
If your beer taps will be closed for more than a week, you need to flush and clean the lines. If you don’t, your lines will grow bacteria and funk up the beers. Save yourself this step and call your local beer distributor to have them flush the lines for you.

Cover and Seal Liquor Bottles
Do this to prevent fruit flies and other insect infestations.

Kitchen/ Bar

Shut off all equipment

  • Unplug counter mounted electric powered equipment (microwaves, blenders, mixers, etc.)
  • Close gas valve to all-natural gas equipment (stoves, overs, flat-tops, salamanders, etc.)
    • Ensure kitchen hood systems and associated hood make-up-air systems are shut down on lines where gas has been shut off
  • Turn off circuit breakers to all large electric powered equipment (combi-ovens, grills, fryers etc.)
  • Shut down ice machines. Remove and discard all ice in the machine and follow the proper start-up procedures when turning machines back on including replacement of the water filter.
  • It is recommended that refrigeration equipment remain operational, even if empty.
  • Move Remaining Food to Walk-In Coolers
    If you have food supplies that will last beyond your temporary closure, move these items from all small refrigerators and freezers to your walk-in cooler/freezer. If you do this, make sure you sanitize the interior of small refrigeration units and ice machines.
Remove Grease from Frying Units

You’ll want to remove all grease from frying units and grease cooking units. Your frying units hold a lot of excess food particles that won’t show up when regularly held in hot temperatures. If you bring these to room temperature, things will start to grow. Make sure you clean your fryers after you’ve removed the food and before you leave.

General Building

Shut off or reduce lighting.

Shut off power to all non-critical electrical equipment.

Electrical power should be maintained for all equipment related to fire and life safety, building HVAC, and other equipment or systems needed during the closure.

Zone temperatures for comfort cooling or heating can be set to an energy conservation setting in unoccupied or lightly occupied areas.

  • Temperatures should never be allowed to go below 55*F or above 85*F.
  • Humidity should be maintained between 40% and 60% relative humidity in occupied buildings and should never go below 30% or above 65% in buildings closed for business.

Exterior building lighting should remain on as a security measure. Building signage lighting and drive-thru signage should be turned off.

Check building exterior to ensure roof access is secured

Check roof cover for water puddles/leak damage; interior ceiling for signs of recent water damage

Confirm fire sprinkler waterflow visual and audible alarms and central station monitoring (if applicable) are operational

Again, confirm building heating temperatures remain above freezing if the fire sprinkler system is Wet design. Purpose:  Avoid sprinkler pipe splitting / joint leaks due to frozen water in pipes/sprinkler head.

Secure all exterior doors but ensure all fire exits remain fully operational.

If you have questions regarding your specific building systems and whether they should be shut down, please reach out to your Area Director.

Good housekeeping both inside and outside, including removal of trash and weeds, to remove combustible materials

Examples of the critical equipment that should NOT be shut down during a partial or full building closure include, but are not limited to, the following:

Fire Alarm System – Consider contacting local PD & FD to notify the building will be unoccupied

Fire Sprinkler System Controls

Emergency Lighting

Fire Pump

Computer Room AC

Domestic Water Pumps

Sewage Ejection Pumps

Sump Pumps or Lift Stations (Dewatering Pumps)

Security Systems, Cameras, and Monitors

Phone System – if possible, forward phones to monitored number

Building Automation System

Keep all HVAC system components operational, and set to energy saving temperatures

  • This prevents indoor air quality issues later.
  • This equipment includes chillers, cooling towers, air handlers, MAUs, FCUs, exhaust fans, etc.
Ensuring Water Safety During Partial or Full Building Closure

Depending on the length of the partial or full building closure it may be necessary to flow water at multiple locations throughout the building to prevent the water from stagnating and to prevent the need for a required disinfection of the system later.

  • Run water in areas that have been closed for more than 7 days.
    • Flowing both hot and cold water for 5 minutes minimum, every 7 days, will prevent the water from becoming stagnant and prevent odors from emanating from the drains.
  • Public restrooms, back of house sinks should also be included in this round if closed for more than 7 days.
  • During this round it is recommended to also pour fresh water down floor drains to keep the traps wet and prevent odors from emanating from the drains.
Safety and Security of Premises

Stop or forward mail and newspapers to an appropriate address or have it picked up on a regular basis. Even if all mail is stopped, the building should be checked at least weekly to ensure unread mail, flyers, leaflets, etc., do not build up and add to the unoccupied appearance of the property

Ensure video surveillance system remains operational in the event of vandalism or intrusion to the building.

Verify communication protocols are in place with monitoring companies

Post signs about security measures, such as alarms, closed circuit television to deter potential trespassers

Ensure camera lenses are clear of obstacles that may obstruct vision.

Verify Wi-Fi capabilities during shutdown period.

If cameras are used for playback only, identify personnel for periodic monitoring during the